61 61 100 Removing and installing/replacing both windshield wiper arms

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, and 2001 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see SPECIAL TOOLS - X-5 (3.0i) .

Special Tools Required:

61 6 060

Remove cover (1).

Fig 1: Removing Cover On Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nut (1).

Installation:

Tighten nut to appropriate torque, (30 N.m).

After waiting 15 minutes, retighten nut to appropriate torque, (30 N.m).

Fig 2: Removing/Installing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not bend wiper arm during removal (risk of breakage).

Detach windshield wiper arm with special tool 61 6 060.

Replacement:

Remove wiper blade.

Fig 3: Detaching Windshield Wiper Arm With Wiper Arm Puller

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust position of wiper arm in question in rest position (measured between wiper lip and top edge of cowl panel cover).

Then tighten down wiper arm and check position of relevant wiper arm again.

54+/-3 mm.
55+/-3 mm.

Fig 4: Identifying Adjustment Measurements Of Wiper Arms
Courtesy of BMW OF NORTH AMERICA, INC.