61 31 020 Removing and installing ignition switch

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, and 2001 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Remove upper section of steering column trim. Refer to STEERING COLUMN TRIM (UPPER SECTION) .

Remove lower section of steering column trim. Refer to STEERING COLUMN TRIM (LOWER SECTION) .

Unlock plug connection (1) and disconnect.

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Move fixture (2) for wiring harness slightly.

Fig 2: Loosening Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove sealing varnish and release headless setscrews (1).

Detach ignition switch (2) in direction of arrow.

Fig 3: Removing Sealing Varnish And Releasing Headless Setscrews

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Secure headless setscrews with sealing varnish.