61 62 030 Replacing wiper arm for rear window wiper

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, and 2001 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see SPECIAL TOOLS - X-5 (3.0i) .

Special Tools Required:

61 6 060

Lever out cap (1) at side and remove.

Fig 1: Removing Lever Out Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) of cap (2) must not be damaged.

Fig 2: Identifying Catches Of Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nut (1).

Installation:

Observe tightening torque, (13.5 N.m).

Fig 3: Unscrewing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Detach wiper arm (1) with special tool 616 060 and remove.

Fig 4: Detaching Wiper Arm With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Wiper motor must be in end position.

Adjust distance (1) between wiper arm and rear window edge.

(1) 32.5+/-2mm.

Fig 5: Adjusting Distance Between Wiper Arm And Rear Window Edge

Courtesy of BMW OF NORTH AMERICA, INC.