51 11 050 Removing and installing/replacing member (cross-member) for front bumper trim

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, and 2001 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary Preliminary Tasks:

Remove underride protection. Refer to 51 71 378 REMOVING AND INSTALLING/REPLACING UNDERRIDE PROTECTION .

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Lever lower trim (3) out of guide (1).

Unlock catches (2) and remove trim (3) in direction of arrow.

Fig 1: Removing Trim Out Of Guide

G03255595

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable ties (1).

Disconnect plug connections (2) for fanfare horns.

Fig 2: Disconnecting Plug Connections For Fanfare Horns

G03255596

Courtesy of BMW OF NORTH AMERICA, INC.

Release expander rivet (1) from fan impeller (2).

Fig 3: Releasing Expander Rivet From Fan Impeller

G03255597

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For vertical adjustment, mark position of member (3).

Release screws (1).

Release nuts (2) and remove member (3) towards front.

Fig 4: Locating Nuts And Screws On Member

G03255598

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty metal nuts (1).

Fig 5: Identifying Faulty Metal Nuts

G03255599

Courtesy of BMW OF NORTH AMERICA, INC.

Stud bolts (2) on member (3) must not be damaged.

Installation:

If necessary, replace faulty metal nuts (1) on member (6).

Fig 6: Identifying Components On Cross-Member

G03255600

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release nut (3) and remove fanfare horns (2).

Version Up To 10/03:

Release welding spots (4), remove holder (5) and protect bright metal plate against rusting.