26 20 000 Removing and installing front propeller shaft

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, and 2001 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not move car by means of engine power once drive shaft has been removed.

Necessary Preliminary Tasks:

Remove reinforcement plate.

Important notes on installation are described in this work step.

Unfasten screws.

Fig 1: Removing Front Propeller Shaft Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace self-locking nuts.

Tightening torque, refer to 26 11 7AZ/8AZ in PROPELLER SHAFT - TIGHTENING TORQUES - X5 .

Push propeller shaft back.

Remove flexible disk with centering flange.

Fig 2: Removing Flexible Disk With Centering Flange

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check sealing ring and replace if necessary.

Fig 3: Checking Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Fit flexible disk must in such a way that arrows point to flange arms.

Fig 4: Fitting Flexible Disk

Courtesy of BMW OF NORTH AMERICA, INC.

Detach propeller shaft from transfer box.

NOTE: Apply a thin coat of grease to splines. Grease: WEICON ANTISIZE.

Fig 5: Removing Propeller Shaft From Transfer Box

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check centering mount (1).

Fig 6: Identifying Centering Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Replace a damaged centering mount.

Grease centering mount.

Grease, refer to BMW SERVICE OPERATING FLUIDS .