26 11 160 Replacing constant-velocity joint for propeller shaft

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, and 2001 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see SPECIAL TOOLS - X5 .

Special Tools Required:

23 1 040
24 1 040
26 1 070
26 1 110

Remove propeller shaft.

Lift out retainer.

Installation:

Replace retaining ring.

Fig 1: Removing Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Drive out knurled pin.

Installation:

Install shims (1).

Fig 2: Installing Shim

Courtesy of BMW OF NORTH AMERICA, INC.

Press gaiter off constant velocity joint.

Installation:

Inject new grease into constant velocity joint from rubber gaiter and flange sides.

Insert sealing washer (1) in constant velocity joint.

Fig 3: Inserting Sealing Washer In Constant Velocity Joint

Courtesy of BMW OF NORTH AMERICA, INC.

Detach constant velocity joint with special tool 26 1 070 or 26 1 110.

Fig 4: Detaching Constant Velocity Joint With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Drive on constant velocity joint with special tool 23 1 040 or 24 1 040 as far as it will go.

Fig 5: Installing Constant Velocity Joint With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Shoulder (1) for sealing washer must point to gaiter.

Fig 6: Aligning Sealing Washer Shoulder

Courtesy of BMW OF NORTH AMERICA, INC.

Toothing must be free from grease.

Thread locking: apply Loctite 648.

IMPORTANT: Keep Loctite out of ball paths. Clean toothing and apply a light coating of oil.