LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 434 (General Electrical System - Service Techniques) >> Exterior mirrors E60, E61, E63, E64 >> Introduction

Exterior mirrors E60, E61, E63, E64: Introduction

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2006 BMW Z4, 2006 BMW M3, 2006 BMW M Roadster, 2006 BMW M Coupe, and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Electric exterior mirrors are fitted as standard to the driver's and front-passenger door. The exterior mirrors are adjusted centrally at the switch block in the driver's door. The switch block is connected to the LIN bus.

The following optional extras are available:

The driver's mirror memory is controlled by the driver's seat module (SMFA).

>Up to 09/2005 

The exterior mirrors are actuated by the driver's door module (TMFA) and by the front-passenger door module (TMBF). The door modules communicate with each other on the byteflight  .

>From 09/2005 

The door modules and the byteflight  are discontinued. The body gateway module (KGM) actuates the exterior mirrors. In the basic equipment specification, the exterior mirrors are electrically adjusted and heated. With the special equipment listed above, the exterior mirrors are connected to the body gateway module (KGM) via the LIN bus. The electrochromic interior mirror is likewise connected to the KGM.

For more information, refer to EXTERIOR MIRRORS SYSTEM OVERVIEW: E60, E61, E63, E64 .