54 10 120 Replacing seal for glass slide/tilt sunroof lid
WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove glass slide/tilt sunroof lid, refer to 54 10 100 REMOVING AND INSTALLING GLASS TILT SUNROOF LID .
NOTE:
Follow repair instructions for bonded seals on glass slide/tilt sunroof, refer to 54 0 ... REPAIR INSTRUCTIONS FOR BONDED SEALS
.
Detach seal (1) for glass sunroof from body.
Installation:
Clean bonding surface with adhesive remover.
Partially pull off protective film from adhesive tape (2).
Press seal (1) without stretching (squashing).
Stick on seal (1) in stages.
IMPORTANT:
Do not touch bonding surface. Surface temperature are equal to or greater than 20°C. Incorrect bonding of the seal will result in leakage.