11 13 000 Removing and installing, sealing or replacing oil sump (N20) AWD

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Drain and add ENGINE OIL .
Remove FRONT AXLE DIFFERENTIAL .
Remove BEARING SUPPORT .

Disconnect plug connection on oil level sensor.

Release screws (1) and remove brackets for engine oil pipe.

Release bolts along line (2).

Tightening torque: 11 13 4AZ .

If applicable, remove or reposition oil level sensor.

Tightening torque, 11 13 7AZ .

If applicable, remove or reposition bearing support.

Installation note:

Replace O-ring.

Fig 1: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: There must be no adhesive residues in the lower crankcase section retaining threads.
Clean retaining threads and sealing surfaces .

Installation note:

Replace gasket (1).

Fig 2: Identifying Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.