41 00... Body Gap Dimensions

The dimensions specified in this service information are applicable at an object temperature of 20°C. The aim of adjustment is to achieve a uniform gap. 

Symmetry of the gaps between left and right sides of the vehicle has top priority. 

The door gaps must not deviate between the front and rear gap by more than 1.0 mm. 

No gap dimension are specified for components which cannot be adjusted. 

Dimensions in mm 

Fig 1: Front Bumper, Hood, Headlamp, Front Fender And Front Pillar Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Roof Panel And Sunroof Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Front Fender, Front Door, Rear Door And Door Sill Trim Panel Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Rear Door, Quarter Panel And Door Sill Trim Panel Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 5: Trunk Lid, Quarter Panel, Tail Lamp And Rear Bumper Body Gap Dimensions And Measurement Points

Courtesy of BMW OF NORTH AMERICA, INC.