11 78 533 Replacing right control sensor (N63O1)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
WARNING:
Risk of burning!
Only perform repair work after engine has cooled down.
Only perform repair work after engine has cooled down.
Necessary preliminary tasks:
- Check function of DME control unit
- Switch off ignition
- Remove ENGINE COVER
Installation note:
The threads of new oxygen control/monitoring sensors are already coated with NEVER-SEEZ COMPOUND .
If a lambda control/monitoring sensor is to be reused, apply a thin and even coating of Never-Seez Compound to the thread only.
The part of the lambda control/monitoring sensor which projects into the exhaust branch (sensor ceramics) must not be cleaned and not coated with lubricant.
Secure control sensor with special tool 11 7 020 and a torque wrench (1).
Tightening torque 11 78 1AZ .
Installation note:
Check function of DME control unit.
Pay attention to cable routing of control sensor.