51 71 482 Removing and installing / replacing left or right tension strut (on rear axle) (M5, M6)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle Do not drive vehicle without
tension strut installed; failure to comply with this instruction will result in damage to the body!.
Release screws (1 and 2).
Remove tension strut (3).
Installation:
Replace screws.
Tightening torque: see 3AZ in 51 61 REINFORCEMENT, BODY .