51 42 060 Removing and installing/replacing armrest in rear door, left or right
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- REMOVE rear door handle
NOTE:
Armrest is welded to door trim panel only on initial installation. The armrest is screw-connected on second installation. If applicable, release screws instead of welding spots.
IMPORTANT:
Risk of damage!
To avoid damaging the contact surface, only drill down to door trim panel area (2)
To avoid damaging the contact surface, only drill down to door trim panel area (2)
Drill out all welding spots in marked area (1) on door trim panel (2) with 8 mm dia. welding spot drill bit.
Remove welding remains on door trim panel (2) with scalpel (for heavy duty use).
Replacement:
Saw off all welding pins (1) along moulding (2).
Insert armrest in door trim panel.
Installation note:
Welding pins (1) are not to protrude over door trim panel (2).
Installation note:
Secure armrest with repair screws (1).
Tightening torque: 51 42 4AZ .