51 22 300 Removing and installing/replacing weather strip on outside of rear door
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
Weather strip in plastic design cannot be removed without damage.
Observe PROCEDURE for using special tool 00 9 324 .
The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.
Observe PROCEDURE for using special tool 00 9 324 .
The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Pry out weather strip (1) with special tool 00 9 324 (starting at B-pillar).
In areas that cannot be reached with special tool 00 9 324 , carefully pry out weather strip (1) using special tool 00 9 325 .
Installation note:
Moisten weather strip (1) before installation with APPROVED LUBRICANT .
Weather strip (1) must lie flush with the door edge at the front and rear.