Storage Location

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Consisting of:

0491851 Spindle
NOTE: With 2 nuts and 2 washers
0491852 Bush
NOTE: (Slip bush) For installing the rubber mount in the front axle support
0491853 Bush
NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential housing
0491854 Pipe
NOTE: (Support tube) For installing the rubber mount in the front axle support - series: E12

Fig 1: Identifying Device AM (311000)
Courtesy of BMW OF NORTH AMERICA, INC.
0491855 Washer
NOTE: (Flanged washer) For centring of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones - series: E12
0491856 Synchronising key
NOTE: For removing and installing the rubber mount in the front axle support - series: E12
0491857 Bush
NOTE: For installing the rubber mount in the front axle support - series: E12
0491858 Bush
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones
0491859 Bush
NOTE: (Bush) Deletion, only available via tool set