28 00 101 Installing replacement transmission (GS7 D36 SG)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Drain transmission oil at oil drain plug.
Tightening torque: 8 Nm.
IMPORTANT:
After completion of work, program transmission control unit.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
IMPORTANT:
- Before installing exchange transmission, always FLUSH TRANSMISSION OIL COOLER TOGETHER WITH LINES .
- After completion of repair work, check TRANSMISSION OIL LEVEL
.
Replacement transmission is supplied filled with transmission fluid.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Necessary preliminary tasks:
- Remove TWIN-CLUTCH GEARBOX .
IMPORTANT:
Make sure the acoustic insert (2) is fitted correctly when removing and installing the transmission.
Installing the acoustic insert (2) for the installation of a replacement transmission is absolutely required.
Installing the acoustic insert (2) for the installation of a replacement transmission is absolutely required.
NOTE:
Release screws.
Remove and convert transmission bearing block (1).
Remove and convert transmission bearing block (1).
Modify all transportation retainers.
Convert all cable clips.
Convert all seal plugs.
Convert protective cap on input shaft.
Transmission identification:
- On type plate