26 11 020 Replacing center mount gaiter: Notes
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove PROPELLER SHAFT .
NOTE:
The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Pull apart propeller shaft.
Installation note:
If necessary, insert new clamping ring (1) into front propeller shaft (2).
Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.
Installation note:
Apply an even coating of grease to longitudinal splines on shaft.
Grease, refer to BMW-SPECIFIED GREASE .
Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).
Push gaiter (1) during installation into groove (2) and make sure it is firmly fitted.