26 12 001 Replacing complete propeller shaft center bearing (constant velocity joint) (M6)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Remove PROPELLER SHAFT .

IMPORTANT: Propeller shaft is balanced as a unit.

Mark the front propeller shaft to the rear propeller shaft with a paint pen.

Marking with major surface damage (e.g. punch mark) is not permitted.

Fig 1: Mark Front Propeller Shaft Relative To Rear Propeller Shaft With Paint Stick

G04749011

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Pull apart propeller shaft.

Installation note:

Thread free of grease.

Make sure that the marks match when sliding the unit together.

Install screw (1) with screw locking.

Tightening torque 26 11 9AZ .

Fig 2: Identifying Screw

G04749012

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the shim and/or dust guard.

Fig 3: Locating Shim/Dust Guard

G04755810

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the center mount with special tool 00 7 500 /33 1 307 and conventional pull-off tools.

Fig 4: Removing Center Mount

G04749014

Courtesy of BMW OF NORTH AMERICA, INC.

Drive new center mount firmly up to limit position with special tool 24 0 090 and/or 24 1 050 .

NOTE: Inner bearing diameter 30 mm, use special tool 24 0 090 .
Inner bearing diameter 35 mm, use special tool 24 1 050 .

Fig 5: Installing Center Mount

G04749015

Courtesy of BMW OF NORTH AMERICA, INC.