27 21 030 Replacing radial shaft seal for output to the front axle (ATC 35L)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of repair work, CHECK TRANSMISSION OIL LEVEL .
For these transfer boxes, use approved TRANSMISSION OIL only.

Necessary preliminary tasks:

Remove rear UNDERBODY PROTECTION .
Remove left holder for underbody protection.

Release screws.

Tightening torque 26 11 7AZ .

Remove front propeller shaft at output flange of transfer box and tie to one side.

Installation note:

Replace screws.

Fig 1: Locating Front Propeller Shaft Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Lever output flange (1) out of housing with screwdriver (2).

Lever radial shaft seal out of housing with a suitable tool.

IMPORTANT: Do not damage housing.

Fig 2: Removing Output Flange

Courtesy of BMW OF NORTH AMERICA, INC.

Drive in radial shaft seal with special tool 27 1 450.

Fig 3: Installing Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.