27 10 070 Replacing output flange on rear transfer box (ATC 35L)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved TRANSMISSION OIL .

NOTE:

Replace output flange only together with a new radial shaft seal.
Operations for removal of output flange are identical to replacing RADIAL SHAFT SEAL for output flange.

Installation note:

Thickness of new shim must be determined before output flange is installed.

Determine and note down dimension A of output flange (old and new).

Fig 1: Checking Output Flange Dimension (A)

Courtesy of BMW OF NORTH AMERICA, INC.

Determine and note down dimension B of output flange (old and new).

Fig 2: Checking Output Flange Dimension (B)

Courtesy of BMW OF NORTH AMERICA, INC.

Determine old dimension C, thickness of shim.

Fig 3: Measuring Shim Thickness

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Calculate thickness of new shim:

Add old dimension A of output flange (previous) and old dimension C of shim
Then subtract old dimension B from old result A+C
Subtract dimension B from dimension A of output flange (new)
Then subtract result of step 2 from result of step 1.