28 60 020 Replacing wiring harness (GS7D36SG)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL
.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Before removing the transmission: Drain off transmission fluid.
- Remove TWIN-CLUTCH GEARBOX .
- Remove MECHATRONICS .
- Remove CLUTCH .
Release screw (1).
Release screw (1).
Tightening torque: 6 Nm.
Release aluminum screw (6).
Tightening torque: 5 Nm.
Installation note:
Replace aluminum screw.
Release combination sensor (2) from housing.
Disconnect connector (3).
Removing wiring harness (4) with earth terminal (5) from housing.
IMPORTANT:
Guide earth terminal (5) carefully
through transmission connector bore.
Risk of damage to sealing surface.
Risk of damage to sealing surface.
IMPORTANT:
To disconnect the combination sensor connector:
Press lock together in area (1) and simultaneously detach connector.
Press lock together in area (1) and simultaneously detach connector.