Removal & Installation

WARNING: This page is about a different car, the 2005 BMW 530i, 2005 BMW 525i, 2004 BMW 530i, and 2004 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

(clutch removed)

Lock flywheel with special tool 11 2 170.

Fig 1: Locking Flywheel With Special Tool

G03260534

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws and remove flywheel.

Fig 2: Unfastening Screws And Remove Flywheel

G03260535

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check dowel sleeve for damage and correct installation position.

Fig 3: Checking Dowel Sleeve For Damage

G03260536

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position of dowel sleeve (1) in dual-mass flywheel is identified by two notches next to associated bolt hole.

Fig 4: Positioning Dowel Sleeve In Dual-Mass Flywheel

G03260537

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean thread and install new micro-encapsulated screws.

Tightening torque, see 11 22 1AZ in ENGINE - TIGHTENING TORQUES .

Fig 5: Installing Micro-Encapsulated Screws

G03260538

Courtesy of BMW OF NORTH AMERICA, INC.