41 14 531 Replacing Engine Support/Front Left Side Frame Connection (Front Left Wheel Arch Removed)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Observe procedure for REPAIR STAGE 3 .

Read contents of BODY, GENERAL .

Removing the engine support side frame connection:

The following new body parts are required:

(1) Connection, wheel arch/entrance

Fig 1: Identifying Wheel Arch/Entrance Connection
Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in areas (1).

Fig 2: Identifying Welded Connections

G06890410

Courtesy of BMW OF NORTH AMERICA, INC.

View from below:

Open welded connections in areas (1).

Fig 3: Identifying Welded Connections

G06890411

Courtesy of BMW OF NORTH AMERICA, INC.

View from below:

Open welded connections in areas (1).

Remove wheel arch/entrance connection.

Fig 4: Identifying Welded Connections

G06890412

Courtesy of BMW OF NORTH AMERICA, INC.

New part preparation

Open welded connections in area (1).

Remove metal section (2).

Fig 5: Identifying Metal Section And Welded Connections

G06890413

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the engine support side frame connection

Install and weld new parts.

NOTE: The bulkhead cross member (1) is filled with low-flammable cavity foam.
In case of smoke formation, stop the welding procedure and cool the welded area with compressed air if applicable.

Fig 6: Identifying Bulkhead Cross Member

G09878537

Courtesy of BMW OF NORTH AMERICA, INC.