41 12 557 Stripping Operations - Replacing Luggage Compartment Floor, Middle (Tail Panel Removed)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Remove exhaust system (job number: 18 00 020)
- Remove heat shields
- Remove left and right trailing links (job number: 51 71 482)
- Remove cross reinforcement (job number: 51 71 480)
- If fitted: Remove active anti-roll bar at rear (job number: 37 12 220)
- Remove carbon canister (FR number: 12 12 010)
Undo nut (1) and remove negative battery cable.
Tightening torque 61 21 6AZ .
Undo nut (2) and cable channel.
Undo positive battery cables (3) from luggage compartment floor and put to one side with cable channel.
Remove battery crash support (4).