33 17 004 Replacing all rubber mounts for rear axle final drive mounting at front (M6)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

2 304 560
2 304 570
2 304 572
2 155 744
2 208 574
2 208 576
2 304 575

Necessary preliminary tasks:

Lower REAR AXLE SUPPORT .

IMPORTANT: Risk of damage!

Place plastic wedge (2) under rear axle differential oil sump (1).

Fig 1: Identifying Rear Axle Differential Oil Sump And Plastic Wedge

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque 33 17 1AZ .

Remove screws with balance weights (2).

Carefully set down rear axle differential with oil sump on plastic underlay.

Installation note:

Renew screws and nuts (1).

Fig 2: Identifying Rear Axle Differential Absorber Weight And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out rubber mount with special tools 2 304 560 , 2 304 570 , 2 304 572 , 2 155 744 , 2 208 574 and 2 208 576.

Fig 3: Pulling Rubber Mount Using Special Tools (2 304 560)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Observe installation position of rubber mount (1)!
Slot (2) parallel to rear axle level.
Multiple pressing in and out of rubber mount (1)
is not permitted.

Fig 4: Identifying Rear Axle Level Slot And Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Coat new rubber mount and bearing bush in rear axle support with Circo Light.

Draw in rubber mount (1) with special tools 2 304 575 , 2 304 572 , 2 155 744 , 2 208 574 and 2 208 576 as far as it will go.

Fig 5: Identifying Special Tools (2 304 575)

Courtesy of BMW OF NORTH AMERICA, INC.