33 33 040 Removing and installing/replacing reinforcement plate

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Driving without reinforcement plate is not permitted!

Necessary preliminary tasks:

REMOVE THE DIFFUSER .

Release screws (1).

Tightening torque 51 61 16AZ .

Installation note:

Replace screws (1).

Fig 1: Identifying Reinforcement Plate Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (2).

Tightening torque 33 33 5AZ .

Remove reinforcement plate to the rear.