66 53 013 Calibrating reversing camera

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Calibration of reversing camera must be carried out after the following work:

Removal and installation/replacement of reversing camera
Body repair work at rear end of vehicle
Adjusting work at tailgate

IMPORTANT: Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:

Vehicle standing level on headlight aiming station
Rear seat bench is unoccupied
Do not swap seats during calibration
Steering wheel in straight-ahead position
Do not move steering wheel

NOTE: Also switch on reversing camera by means of PDC button.

Calibration can only be carried out with the BMW diagnosis system.

Use of a special tool is no longer required from 09/2011.

Service functions:

04 Driver assistance
All-round vision camera
Calibration and teaching in for all-round vision camera