66 20 535 Removing and installing/replacing a rear right ultrasonic transducer (PDC)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of burning.
Work on the exhaust system may only be carried out when it has cooled down.

NOTE: Ultrasonic transducers (3) can be reached from below with bumper installed.

Unlock plug connection (1) and disconnect.

Unlock latch mechanisms (2) and pull ultrasonic transducer (3) out of bracket.

Installation note:

Before installation of ultrasonic sensor (3) on wiring harness, clean plug connection.

Retaining tabs (2) must not be damaged.

Make sure ultrasonic sensor is securely seated.

Fig 1: Identifying Latch Mechanisms, Ultrasonic Transducer And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Fig 2: Identifying Rubber Ring Seated On Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.