66 54 001 Axially adjusting night vision camera

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Mechanical setting - as described in the following - is only possible axially .
Vertical alignment can only be carried out with the BMW diagnosis system:

Service functions
-> Driver assistance systems

-> Night vision electronics

-> Calibration night vision electronics camera

NOTE: Installation location: Adjusting screw, Night Vision Camera F07, F10, 11, 18, F12, 13:

Fold up engine compartment lid seal (1) as shown.

NOTE: (2) = Installation location, adjusting screw, night vision camera

Fig 1: Identifying Installation Location

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Front of vehicle must be parallel at distance (A) to headlight aiming device (1).

(A) = 2 m

Align a suitable straight object (2), e.g. a spirit level, horizontally on headlight aiming device.

Slowly carry out axial adjustment of night vision camera at adjusting screw (3).

Fig 2: Positioning Front Of Vehicle And Headlight Aiming Device

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Image shows the CID picture in the vehicle.

If necessary, align the image of the night vision camera with aid of a second person.

Yellow help line (1) is displayed using diagnosis job.

Upper edge (2) must be aligned parallel to yellow help line (1) in the CID using adjusting screw.

Fig 3: Aligning Upper Edge To Yellow Help Line

Courtesy of BMW OF NORTH AMERICA, INC.