32 41 437 Removing and installing/replacing Dynamic Drive return from separation point to cooling loop

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 1 270

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Close off line connections with seal plug. 32 1 270

Recycling:

Catch and dispose of hydraulic fluid in a suitable collecting vessel.

Necessary preliminary work:

Remove underbody protection at front and rear . See 51 47 491 REMOVING REFITTING/REPLACING REAR ENGINE UNDERCOVER and 51 47 490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION .
Disconnect BATTERY EARTH LEAD
Remove fan cowl with electric fan (N55/N63). See 17 11 035 REMOVING AND INSTALLING/REPLACING FAN COWL WITH ELECTRIC FAN (N55) or 17 11 035 REMOVING AND INSTALLING/RENEWING FAN COWL WITH ELECTRIC FAN (N63) .
Mark electrical steering gear to front axle support and release, unlock wiring harness, pull off and pull steering gear forwards. See 32 13 070 REMOVING AND INSTALLING ELECTRIC STEERING BOX (EPS) or 32 13 075 REMOVING AND INSTALLING ELECTRICAL STEERING BOX ACTIVE STEERING .

IMPORTANT: Pressure lines must be closed off with suitable seal plugs 32 1 270 immediately after removal!

Release screw (1) in area of lower wishbone.

Tightening torque 32 41 15AZ .

Fig 1: Identifying Screw Of Lower Wishbone

Courtesy of BMW OF NORTH AMERICA, INC.

Release line clips (1) and (2) from front axle support.

Tightening torque 37 13 7AZ .

Fig 2: Identifying Front Axle Support Line Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock return line on cooling loop and disconnect.

Remove return line.

Fig 3: Identifying Return Line On Cooling Loop

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: When assembling, make sure that in succession only the seal plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.

After installation:

Carry out INITIAL DYNAMIC DRIVE OPERATION
Check pipe connections for leaks