32 41 426 Replacing expandable hose part 2 for hydraulic steering (S63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.

Recycling:

Catch and dispose of hydraulic fluid in a suitable collecting vessel.

Observe country-specific waste disposal regulations

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid from oil reservoir
Remove front underbody protection
Remove STIFFENING PLATE
Remove left steering assembly COVER

Release screw (1) and remove return line (3).

Disconnect pressure line (2).

Installation note:

Replace all sealing rings.

Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.

Tightening torque 32 41 5AZ .

Fig 1: Identifying Hydraulic Steering Gear Line And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw connection (1) and remove line in downward direction.

Tightening torque 32 41 15AZ .

Fig 2: Identifying Screw Connection

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and bleed HYDRAULIC SYSTEM
Check line connections for leak tightness