32 41 285 Replacing level switch for Dynamic Drive fluid reservoir

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front left SUSPENSION CROSS-BRACE
Remove intake port for air filter housing. See 13...... REMOVING INTAKE DUCT (N55) or 13...... REMOVING INTAKE DUCT (N63) .

Release screws (1) and (2).

Remove washers.

Tightening torque 32 41 1AZ/2AZ .

Remove fluid reservoir by pulling upwards.

Fig 1: Identifying Screws On Wheel Arch And Expansion Tank

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Raise and/or turn fluid reservoir in order to gain better access to plug connection.

Disconnect plug connection (1).

Turn level switch (2) through approx. 45° and remove towards bottom.

Fig 2: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.