32 31 211 Removing and installing/replacing universal joint with corrugated tubing (S63)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If the lower section of the steering shaft is separated from the steering box/steering shaft middle section, the steering column switch cluster may be damaged when the steering wheel is turned.
Necessary preliminary tasks:
- Remove rear UNDERBODY PROTECTION
- Remove REINFORCEMENT PLATE
Release screw (1) on corrugated tubing.
Tightening torque 32 31 3AZ .
Release screws (1) from below.
Tightening torque 32 31 2AZ .
Slide universal joint with corrugated tubing upwards and remove.
Installation note:
Connect universal joint with corrugated tubing first to steering shaft and then to steering box.
Clean screw threads to remove all remnants of screw locking adhesive.
Replace screws.
Screw must rest in steering box groove or steering shaft middle section.
No subsequent retorquing permitted!
After installation:
- Turn steering wheel in both directions to the limit position. The airbag indicator light must not light up in the process.