31 51 015 Replacing shaft seal for left output shaft

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

31 5 130

Necessary preliminary work:

REMOVE left output shaft.

Lever shaft seal (1) out of front axle differential (3) with a fork wrench (2).

Fig 1: Replacing Front Axle Differential Shaft Seal Using Fork Wrench

G08512335

Courtesy of BMW OF NORTH AMERICA, INC.

Install radial shaft seal:

NOTE: The installation protective ring (1) serves to protect the sealing lips of the radial shaft seal (2) when the output shaft is being installed.

Fig 2: Identifying Protective Ring And Radial Shaft Seal

G04794385

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Drive in shaft seal with special tool 31 5 130 up to limit position.

Fig 3: Driving Shaft Seal Using Special Tool 31 5 130

G09849144

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check FRONT AXLE GEARBOX OIL LEVEL , correct if necessary.