13 54 020 Removing and installing/sealing right throttle body (N63O1)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Remove right INTERCOOLER .

NOTE: Picture shows the left throttle body, the procedure for the right side is identical.

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle body (3).

Installation note:

Check the plug connection (1) for coolant residue. If necessary, blow clean plug connection (1) with compressed air.

Fig 1: Identifying Throttle Valve Assembly, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring (1) of throttle body (2).

Fig 2: Identifying Throttle Body Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault message.

Delete fault memory.