13 62 591 Removing and installing/replacing pressure sensor on left charge air cooler (S63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out DME control unit fault memory.
Switch off ignition
Remove left INTAKE FILTER HOUSING

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of left charge air cooler.

Installation note:

Replace sealing ring on pressure sensor.

Fig 1: Identifying Pressure Sensor, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.