17 11 370 Removing and installing/replacing cooling loop for hydraulic steering (N55)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of scalding!
Only perform this repair work after engine has cooled down.

IMPORTANT: When carrying out repair work on the oil and cooling circuit, protect the alternator against dirt contamination.

Cover alternator with suitable materials.

Failure to comply with this procedure may result in an alternator malfunction.

Necessary preliminary work:

Remove FAN COWL .

Release screws (1) on left and right from cover (3).

Tightening torque: 5 Nm

Release screws (2) behind sealing lip.

Tightening torque: 5 Nm

Lift out cover (3).

Fig 1: Identifying Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove circlips (1).

Unlock lines (2) and detach from cooling loop.

Press in latch mechanisms (3) and pull cooling loop upwards.

IMPORTANT: Catch and dispose of emerging oil.

Installation note:

Reinstall circlips.

Fig 2: Identifying Circlips, Latch Mechanisms And Lines

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1) in direction of arrow.

Lift out oil cooling loop (2).

Fig 3: Lifting Out Oil Cooling Loop

Courtesy of BMW OF NORTH AMERICA, INC.

After completing this repair work, check the oil level in the oil reservoir of hydraulic steering. See BLEEDING POWER STEERING UNIT or BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) .

If Dynamic Drive is fitted in the vehicle, execute If Dynamic Drive is fitted in the vehicle, execute START-UP WITH A TEST RUN .

Reassemble the vehicle.

Check hydraulic steering for leak tightness.