17 11 200 Removing and installing/replacing engine oil cooler (S63)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of scalding!
Only perform this repair work after engine has cooled down.
Only perform this repair work after engine has cooled down.
IMPORTANT:
Wear safety goggles and protective gloves.
Necessary preliminary tasks:
- Remove front UNDERBODY PROTECTION .
IMPORTANT:
Adhere to conditions of absolute cleanliness when repairing the engine oil circuit.
When removing engine oil pipes and engine oil cooler, seal off all openings with suitable plugs.
To avoid engine damage, do not allow any dirt particles to get into the engine oil circuit.
When removing engine oil pipes and engine oil cooler, seal off all openings with suitable plugs.
To avoid engine damage, do not allow any dirt particles to get into the engine oil circuit.
Recycling:
Engine oil escapes when engine oil pipes are released. Catch and dispose of emerging engine oil.
Observe country-specific waste disposal regulations.
Release screws (1).
Tightening torque 17 22 4AZ .
Pull engine oil pipes off of engine oil cooler.
Catch and dispose of emerging oil.
Unfasten screws (2).
Tightening torque 17 22 5AZ .
Remove engine oil cooler (3).
NOTE:
After the repair work is completed, check the oil level. Top up engine oil if necessary.