12 63 586 Replacing power distribution module (N55)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .

Release expanding rivets (1) and remove cover (2).

Installation note:

Replace damaged expanding rivets.

Holder of cover (2) must snap into place in suspension cross-brace during installation.

Fig 1: Identifying Cover And Expanding Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover (2).

Release nut beneath it and set positive battery cable aside.

Unlock and pull off all connectors from power distribution module.

Release lock (1) in direction of arrow.

Feed out and remove power distribution box (3).

Fig 2: Identifying Cover, Lock And Power Distribution Box

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.