12 41 020 Removing and installing/replacing starter motor (N55)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .
Remove INTAKE PLENUM .

Unlock connector (1) and remove.

Release nuts (2) and disconnect positive battery cables.

Tightening torque 12 42 2AZ .

Release screws (3).

Installation note:

Tightening torque 12 41 1AZ .

Remove starter motor (4).

Fig 1: Identifying Connector, Nuts, Screws And Starter Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check starter pinion and ring gear for damage. Replace starter motor if necessary.

Only during starter replacement and on vehicles with MSA (automatic engine start-stop function):

Use BMW diagnosis system to reset the starter counter.