12 61 285 Removing and installing/replacing oil level sensor for engine oil (S63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Switch off ignition.
Remove STIFFENING PLATE
Drain ENGINE OIL .

Unlock connector (1) and remove.

Unscrew nuts (2).

Tightening torque 12 61 2AZ .

Remove oil level sensor.

Installation note:

Clean sealing surface on oil sump.

Replace seal on oil level sensor.

An excessively low torque value will result in oil leaks.

An excessively high torque value will result in damage to the oil level sensor.

Fig 1: Identifying Connector And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Top up engine oil.

NOTE: Check stored fault message.
Delete fault memory.