12 61 280 Removing and installing/replacing oil pressure sensor (S63)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Switch off ignition.
- Remove STIFFENING PLATE
WARNING:
Risk of burning!
Only perform this repair work on an engine that has cooled down.
Only perform this repair work on an engine that has cooled down.
Installation location:
Oil pressure sensor is located next to the oil filter housing.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock connector (1) and remove.
Release oil pressure sensor (2).
Tightening torque 12 61 1AZ .
Installation note:
Check engine oil level. Top up engine oil if level is too low.