12 14 513 Replacing pulse sensor on right exhaust camshaft (N63O1)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

Read out fault memory of the DME control unit, work through test plans if necessary.
Switch off ignition.
Remove right-hand INTAKE SILENCER HOUSING .

Partially release wiring harness if necessary.

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 62 3AZ .

Remove pulse generator (3).

Fig 1: Identifying Pulse Generator, Screw And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring and coat with lubricant.

NOTE: Delete fault memory.