61 61 270 Removing and installing or replacing console for windscreen washer system complete with motor

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Before installing the wiper arms, allow wiper motor to run into rest position.

IMPORTANT: Emergency operation - danger of injury.
Disconnect NEGATIVE BATTERY CABLE
Disconnect both negative battery cables for F03.

Necessary preliminary tasks:

Remove COWL PANEL COVER
Remove LEFT/REAR SUSPENSION CROSS-BRACE for

F01/F02/F03F12F13

Release screws (1).

Tightening torque 61 61 1AZ .

Remove console for windscreen wiper system (2) in direction of arrow and disconnect plug connection (3).

Fig 1: Removing Console For Windscreen Wiper System

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Vacuum line (1) must not be trapped by windscreen washer system (2).

Contact with vacuum line (1) is only permitted at the positions (A/D/C) specifically designed for this purpose.

Fig 2: Identifying Vacuum Line And Windscreen Washer System

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: As of 09/2009, an additional holder (1) is installed for the vacuum line (2).

Installation note:

Make sure the vacuum line (2) is correctly seated in the holder (1).

Fig 3: Identifying Holder And Vacuum Line

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: After installing, check freedom of movement between wiper kinematics and vacuum line.