61 35 132 Removing and installing/replacing central gateway module
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary work:
- Disconnect BATTERY EARTH LEAD
- Disconnect both negative battery cables at F03
- Remove TRIM PANEL FOR PEDAL MECHANISM .
Disconnect plug connection (1).
NOTE:
Cable shoe (4) is currently no longer installed.
If installed, release screw (2) and remove cable shoe (4).
Tightening torque 61 35 3AZ .
Pull central gateway module (3) off equipment holder (5) in direction of arrow.
Installation note:
Make sure central gateway module (3) is correctly installed in equipment holder (5).
Replacement:
Carry out PROGRAMMING/ENCODING .
Perform FlexRay synchronization via path:
- Body
- Central Gateway Module
- Initialize FlexRay