51 76 030 Removing and installing/replacing rear engine hood/bonnet seal

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Up to 08/2008:

Open and detach left and right service flaps (1).

From 09/2008:

Remove SERVICE FLAPS (1)

Feed out seal (2) and lay to one side.

NOTE: If necessary, detach front engine compartment lid seal (3) in operating range.

Fig 1: Removing Seal

Courtesy of BMW OF NORTH AMERICA, INC.