LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3782 (Collision - Body Panel Repair (F12) Convertible) >> Front Lid >> 41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Danger of injury!
The BATTERY EARTH LEAD must be clamped off on vehicles with AFGS active pedestrian protection!
Adhere to the following SAFETY INFORMATION so as to avoid a danger of injury by the actuator.
IMPORTANT: Support engine compartment lid in fully opened position with suitable apparatus.
Removal of the engine compartment lid must be carried out with the assistance of a second person.

Follow instructions on ACTIVE PEDESTRIAN PROTECTION system.

Necessary preliminary tasks: 

Disconnect NEGATIVE BATTERY CABLE .

Unscrew nuts (1).

Remove engine compartment lid.

Installation note: 

Install engine compartment lid at screw locations to on hinge.

Tightening torque 41 61 1AZ .

If necessary, adjust engine compartment lid. See 41 61 014 ADJUSTING ENGINE COMPARTMENT LID .

Fig 1: Identifying Engine Compartment Lid And Hinges Nuts
G04791372Courtesy of BMW OF NORTH AMERICA, INC.