66 32 020 Removing and installing/replacing sensor for lane change warning on left or right

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear bumper panel. See 51 12 156 REMOVING AND INSTALLING (REPLACING) REAR BUMPER PANEL .

Fig 1: Identifying Sensor, Screw And Plug Connection
Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screw (3).

Remove sensor (2).

Installation note:

Ensure that the guides are correctly seated at the marked locations.

Replacement:

Modify frame (2) for new sensor (1).

Fig 2: Identifying Frame And Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: If, in the event of side damage to the vehicle, it is not necessary to replace the tail panel, observe the following points:
Fit middle bumper panel guide on undamaged side
Use middle bumper panel guide as a gauge in order to check or correct the position of the remaining connecting points.
Middle bumper panel guide must be a to be fitted without tension.

Replacement:

Carry out VEHICLE PROGRAMMING AND ENCODING .

Replacement after body repair:

Execute diagnosis job
>
- Start-up
  - Lane change warning sensor system