28 10 020 Removing and installing or replacing combination sensor (GS7D36SG)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL
.
Use only the approved transmission oil .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the approved transmission oil .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Remove TWIN-CLUTCH GEARBOX .
- Remove CLUTCH .
Release screw (1).
Tightening torque: 6 Nm.
Release combination sensor (2) from housing.
Disconnect connector (3).
Installation note:
Replace screw.
IMPORTANT:
Do not
where possible release cable (4) from bracket (5).
Installation note:
If bracket (5) does have to be released, replace aluminum screw (6).
Tightening torque: 5 Nm.
IMPORTANT:
To disconnect the combination sensor connector:
Press lock together in area (1) and simultaneously detach connector.
Press lock together in area (1) and simultaneously detach connector.