26 11 090 Removing and installing/replacing centering mount for propeller shaft
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 31 4 150
- 11 2 350
- 00 5 500
Necessary preliminary tasks:
- Remove PROPELLER SHAFT .
Completely fill centering bore hole (1) with viscous grease.
Drive special tool 31 4 150 with a plastic hammer into centering bore hole.
The centering bearing (1) is forced out of the propeller shaft by the pressure on the grease filling.
If necessary, top up grease repeatedly.
Installation note:
Remove grease from bearing hole.
Drive in centering mount (1) with special tools 11 2 350 and 00 5 500 into propeller shaft (observe protrusion).
Grease centering mount.
- Grease: DRIVESHAFT -- OPERATING FLUIDS
Installation note:
Observe protrusion A = 7 mm of centering element (1).